Early spring: before the first hot week
This is the visit that pays for itself. A unit that has sat unused through winter can have a drain pan full of debris, a nest or insects in the outdoor unit, and a filter matted with dust. Running it for the first time on a 32 degree day is the worst possible test.
- Clean or replace indoor filters
- Clear leaves and debris from around the outdoor unit
- Check the condensate drain runs freely
- Run the unit in cooling for 20 minutes and note any odd noise or smell
- Book a service if it has been more than a year
Summer: the humid months
Through the humid weeks, drainage becomes the weak point. A partially blocked drain that copes in dry weather will overflow when the unit runs for hours and produces condensate continuously. Check for water staining near the indoor unit and listen for gurgling.
Filters also load up faster when the unit runs daily. In a coastal home with windows open, expect to clean them more often than the manual suggests.
- Clean filters every few weeks of heavy use
- Watch for water marks or drips at the indoor unit
- Keep outdoor clearance free; do not stack stored items against it
- Note any room that has stopped cooling as well as it used to
Autumn: the corrosion check
Before the unit goes quiet for winter, look at the outdoor coil and the fixings. This is the point where a rinse and a check of the brackets is cheap, and where advanced fin loss is worth knowing about before next season rather than during it.
- Rinse the outdoor coil gently to remove salt and dust
- Inspect brackets and mountings for corrosion or looseness
- Check the casing and fan guard for damage
- Run the unit briefly once a month through winter to keep seals and bearings free
Winter: heat pump and heating mode
If the same unit heats in winter, it now spends time in defrost. Ice forming on the outdoor coil is normal during defrost cycles; ice that stays for hours is not. A unit that ices heavily and stops heating needs diagnosis, not patience.
Keep the outdoor unit clear of fallen leaves and check that its drain path does not freeze or pool against the wall.
What to leave to a technician
Filter cleaning, visual checks and clearing debris are safe for most homeowners. Refrigerant handling, electrical testing, coil cleaning with chemical products, and anything requiring the casing to come off should be done by someone who can test the system properly afterwards.
A service is not just a wash. It should include operating pressures, electrical draw, temperature differential across the coil, drain flow and a look at the mountings, with findings written down.
Questions on this topic
For most homes, once a year is a sensible baseline. Coastal homes and units that run heavily benefit from more frequent attention, particularly coil cleaning.