1. Is it actually getting power, and is it actually running?
Listen for the compressor. A fridge that is silent apart from the light may have tripped a circuit, failed a plug or blown a fuse. Check the socket with another appliance, check the plug, and check the distribution board.
If you hear a click every few minutes but no sustained running, the compressor is trying to start and failing. That is usually a starter or compressor fault and needs a technician.
2. Can it reject heat?
A fridge needs space at the back and sides, and a condenser that is not packed with dust. Pull the cabinet out if it is safe to do so, look at the back, and clear any matted dust or pet hair. Confirm nothing is pressed against the sides and that the top is not being used as a shelf.
This is a common cause in Fish Hoek garages and enclosed pantries, where a second fridge is squeezed into a hot, unventilated corner.
3. Are the door seals doing their job?
Close the door on a piece of paper at several points around the frame. If it slides out with no resistance, air is getting in. Wipe the gasket clean, check for tears, and look at whether the door hangs square. A sagging hinge can be adjusted; a perished gasket needs replacing.
4. What is the frost pattern telling you?
On a frost-free fridge you should not see heavy frost at all. On a manual-defrost or chest freezer, frost should be even across the evaporator. A patch of frost with a warm area, or no frost at all with a running compressor, points to a refrigerant or airflow problem rather than a thermostat.
- Even frost across the whole evaporator: refrigeration side is probably working
- Frost in one corner only: airflow or charge problem
- No frost and a hot compressor: likely a sealed-system fault
- Thick ice on the back wall: defrost fault or a seal letting moist air in
5. Is it set correctly and is the thermostat lying?
Check the setting has not been knocked to its warmest position, and check the temperature with a fridge thermometer rather than by feel. A fridge holding 4 to 5 degrees Celsius is working; one holding 10 degrees is not, even if it feels cool to the hand.
If the thermostat is set cold and the compressor still does not run, the control or the sensor is suspect and needs testing.
When to stop and call
If the compressor runs continuously and the cabinet stays warm, if there is oil residue or a hiss near the pipework, if the cabinet trips the power, or if frost patterns point to a sealed-system fault, stop there. These need gauges, leak detection and refrigerant handling.
Tell us the make and model, what you have already checked, and whether the freezer section is affected. That saves a diagnostic step and gets you a more accurate quote.
Questions on this topic
It depends on how warm the cabinet has become and for how long. Keep the door closed, and follow food safety guidance for anything that has been above 5 degrees Celsius for an extended period.