Most air-conditioner faults fall into a few families: a system that runs but does not cool, one that trips the power, one that drips, and one that has stopped responding altogether. Each points at a different part of the circuit, and guessing costs money twice. We test operating pressures, electrical draw, airflow and drainage before recommending a repair.
Coastal units bring their own failure modes. Corroded coil fins cut heat transfer, salt residue bridges electrical terminals, and a blocked drain overflows into a ceiling. Where a component is beyond saving we say so plainly, quote the replacement, and explain what a new unit would cost instead.
What this covers
- Not cooling, or cooling weakly
- Tripping the breaker or failing to start
- Water leaking from the indoor unit
- Noisy fan, compressor or vibration
- Error codes and control faults
- Refrigerant leak detection and repair
- Capacitor, fan motor, sensor and PCB replacement
When it is worth calling
- Air comes out but it is not cold
- The unit runs for a few minutes then stops
- Water marks on the wall or ceiling below the indoor unit
- A rattle, hum or hiss that was not there before
Coastal note · Fish Hoek
What salt air and humidity change here
- Salt residue on terminals and connectors causes intermittent faults that look like board failures.
- Corroded fins on the outdoor coil reduce capacity long before the compressor fails.
- Drain pans and lines silt up faster in humid coastal air, so overflow is a common summer call.
Air-conditioning repairs: common questions
Yes. We work on most common split, cassette and ducted systems regardless of who installed them.