A hot-water heat pump is an air-conditioner running in reverse, and it lives outdoors. That makes placement the single biggest decision: it needs airflow, shade from the worst of the afternoon sun, and enough clearance that it is not breathing its own cold exhaust. On the coast it also needs a position where salt spray reaches it least.
We install, service and repair heat pumps for homes and guest houses. Repairs cover the usual suspects: failed fans, control and sensor faults, refrigerant leaks, and ice forming on the evaporator because the unit is starved of air or running in the wrong conditions.
What this covers
- New heat-pump installation and commissioning
- Replacement of ageing outdoor units
- Fan, compressor and control repairs
- Refrigerant leak detection and repair
- Defrost and sensor faults
- Airflow and placement correction
- Annual service and performance check
When it is worth calling
- Hot water running out faster than it used to
- The unit icing up or running constantly
- Loud fan noise or vibration
- Water pooling under the unit
Coastal note · Fish Hoek
What salt air and humidity change here
- Salt air corrodes outdoor coils and fixings; placement and periodic cleaning extend service life.
- Humid air increases condensation, so drainage from the unit needs to be clear and correctly routed.
- A unit in a closed lean-to cannot reject heat and will run far longer than it should.
Heat-pump installation and repairs: common questions
In many homes it can carry most of the hot-water load, but the right answer depends on household size, tank size and how you use hot water. We assess before recommending.